Trio-motion-technology MC4N-ECAT Manual do Utilizador descarregar pdf (Página 3)

SERIAL

CONNECTIONS

* Current shared with encoder port

Pin Function Note

1 RS485 Data In A Rx+

Serial Port #2

2 RS485 Data In B Rx-

3 RS232 Transmit Serial Port #1

4 0V Servo/Encoder

5 RS232 Receive Serial Port #1

6 5V Output 150mA max*

7 RS485 Data Out Z Tx-

Serial Port #2

8 RS485 Data Out Y Tx+

A standard Ethernet connector is provided for use as

the primary programming interface.

The Trio programming software, Motion Perfect v3,

must be installed on a Windows based PC that is

ﬁ tted with an Ethernet connection. The IP address is

displayed on the MC4N display for a few seconds after

power-up or when an Ethernet cable is plugged in.

Ethernet cable must be CAT 5 or better.

The Standard Ethernet connection may also be used for

Ethernet-IP, Modbus and other factory communications.



See back page for set-up details.

RJ45

CONNECTOR

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Trio-motion-technology MC4N-ECAT Manual do Utilizador Página 3